top of page
EAMIGROUT HMC
Free Flowing, Non Shrink, Micro Concrete
PRODUCT DESCRIPTION
EAMIGROUT HMC is ready to use cement based
compound, which requires only addition of water to
produce high performance free flowing, non-shrink
micro concrete.
PRODUCT DOCUMENTS
Technical Data Sheet
TYPICAL APPLICATIONS
EAMIGROUT HMC is formulated for applications where micro concrete is needed to be pumped or poured into restricted spaces. Typical applications include grouting & bedding for the following:
-
Structural elements such as pre-cast walls, beams, columns and small sections up to 35 – 40 cm.
-
Milling equipment.
-
Gas & steam turbines.
-
Crane rails.
-
Filling voids around doorframes, precast walls & panels.
-
Narrow or confined areas in concrete structures.
-
Reinstatement of damaged, affected concrete by partial or total replacement.
-
Anchor bolts.
-
It is recommended to be used for sections exceeding 60mm
-
Bridges and bearings supports.
PRODUCT FEATURES
-
Easy to use, only requires on-site addition of water.
-
Excellent flow ability, which facilitates complete filling of narrow voids.
-
Shrinkage compensated system.
-
Contains special graded hard inert aggregates which enhance pump-ability reduces segregation.
-
High bond strength to steel as well as to concrete.
-
Durable concrete with low permeability.
-
Carbonation & chloride ingress resistance.
-
Excellent thermal compatibility with the concrete substrate.
-
Provides early strength development.
-
Specially formulated to be suitable for the Middle East climate conditions.
STANDARDS
EAMIGROUT HMC complies with the requirements of ASTM C -1107, Grade
A, and CRD C-621
bottom of page