top of page

EAMIPAIR FC

Cement-based, Polymer Modified Thixotropic, Cosmetic Mortar for Concrete & Masonry Surfaces

PRODUCT DESCRIPTION

EAMIPAIR FC is single component, polymer & fiber modified cementitious mortar for cosmetic, fairing and skimming of concrete and mineral substrates.
It contains Hydraulic binders, fillers, polymers, fibers, silica-fume and modifiers that permit the mortar to be applied in a thickness more than 3 mm. The hardened product exhibits an excellent thermal compatibility with concrete and outstanding waterproofing & weatherproofing properties.

PRODUCT DOCUMENTS

Technical Data Sheet

TYPICAL APPLICATIONS

EAMIPAIR FC is specially formulated to be used as polymer modified, high strength, non-sag waterproofing cementitious fairing & cosmetic mortar in:

  • Pore sealer, honeycombing and fishing coat upon mineral horizontal, vertical and overhead surfaces prior to application of decorative coatings.

  • As fairing and cosmetic coat to repair any surface defects.

  • On grade and below grade on concrete and mortar.

  • Levelling mortar preparatory to concrete to receive another protective coating.

  • Waterproofing & weatherproofing, fairing and cosmetic render up to 3 mm.

  • Where exceptional chloride and carbon dioxide resistance is required.

  • To provide a uniform surfaces free from defects over repaired areas.

  • All similar applications.

PRODUCT FEATURES

  • Easy to mix and apply.

  • Non-sag & non-shrink.

  • Excellent resistance to carbonation and water soluble salts.

  • Compatible with thermal coefficient of expansion of concrete.

  • Excellent abrasion resistance.

  • Extremely low permeability ensuring durability.

  • Very good resistance to water and waterborne soluble salts.

  • Non-toxic and does not contain any harmful ingredients.

  • Can be applied on horizontal, vertical and overhead surfaces.

  • Excellent resistance to freeze / thaw cycles.

  • Excellent adhesion to concrete and masonry substrates.

  • Smooth and easily produced cosmetic finish.

STANDARDS

EAMIPAIR FC is formulated to comply with all requirements of DIN EN 998 Part 1: “Specification for mortar for masonry, Rendering and plastering mortar”.

bottom of page